Document ID:	MIL-STD-202       Scroll down to access document images
Spec/Std Sheet:	104

Overview

Title:  Method 104, Immersion Scope:  This test is performed to determine the effectiveness of the seal of component parts. The immersion of the part under evaluation into liquid at widely different temperatures subjects it to thermal and mechanical stresses which will readily detect a defective terminal assembly, or a partially closed seam or molded enclosure. Defects of these types can result from faulty construction or from mechanical damage such as might be produced during physical or environmental tests. The immersion test is generally performed immediately following such tests because it will tend to aggravate any incipient defects in seals, seams, and bushings which might otherwise escape notice. This test is essentially a laboratory test condition, and the procedure is intended only as a measurement of the effectiveness of the seal following this test. The choice of fresh or salt water as a test liquid is dependent on the nature of the component part under test. When electrical measurements are made after immersion cycling to obtain evidence of leakage through seals, the use of a salt solution instead of fresh water will facilitate detection of moisture penetration. This test provides a simple and ready means of detection of the migration of liquids. Effects noted can include lowered insulation resistance, corrosion of internal parts, and appearance of salt crystals. The test described is not intended as a thermal shock or corrosion test, although it may incidentally reveal inadequacies in these respects. Status:  Active Document Date:  23-OCT-2024         Next Review Due:  22-OCT-2029 FSC/Area:  59GP Doc Category:   Military Standard -Test Method Standard

Responsibilities

Lead Standardization Activity:  CC  DLA Weapons Support (Columbus)     Preparing Activity: CC  DLA Weapons Support (Columbus) Coordination:  Full   Army Custodian:  CR   US Army Combat Capabilities Development Command, C5ISR Center   Navy Custodian:  EC   Naval Information Warfare Systems Command   Air Force Custodian:  85   Air Force Life Cycle Management Center - Electronic Components, Wire and Ca   DLA Custodian:  CC   DLA Weapons Support (Columbus)

Changes to military standards or handbooks issued after August 1, 2003 are incorporated in the modified document.

Revision History

Click on column headings for a description of column content.

NOTE: It is recommended that you use Adobe Reader v7.0 or higher for optimal download performance; older versions should continue to work, but downloading large files may appear to take longer, so please be patient in those cases.